- Tue Dec 08, 2009 10:02 am
#1873
Here are a few photos of a replica Ribbon Decive I've been commissioned to make.
First off, huge thanks to SG Merc for his help at the early stages of this project when I was trying to figure out the scale and sizes of the arm band. Thanks again it saved a lot of time for me!
The piece is made from solid Brass, with the exception of the two crystals which are both pieces of acrylic that have been carved into shape. The LED in the middle of the palm crystal is activated when the hand is opened fully, and the palm touches a switch on the back of the unit.
There is also a seperate little sound unit which is a set of travel speakers and a cheap MP3 player which you an activate to make the ribbon sound.
Here are few shots, please take a look at my site for a few more photos.
Cheers
Pete
http://www.standingstonestudios.com
First off, huge thanks to SG Merc for his help at the early stages of this project when I was trying to figure out the scale and sizes of the arm band. Thanks again it saved a lot of time for me!
The piece is made from solid Brass, with the exception of the two crystals which are both pieces of acrylic that have been carved into shape. The LED in the middle of the palm crystal is activated when the hand is opened fully, and the palm touches a switch on the back of the unit.
There is also a seperate little sound unit which is a set of travel speakers and a cheap MP3 player which you an activate to make the ribbon sound.
Here are few shots, please take a look at my site for a few more photos.
Cheers
Pete
http://www.standingstonestudios.com
- By graves