- Sat Feb 14, 2009 5:54 am
#1231
All that have the DST Stargate figures will know that the gate and ramp are not in scale with the figures, they should be much larger. That was not a problem until the MALP came around, which was too wide to fit onto the ramp! So I decided to make my ramp a bit wider.
So it looked before:
I bought an extra Thor to get more ramp parts. I did want to make it one half wider, so I needed to cut them in the middle.
The steps were a bit more tricky, since they have a space at the left and right, where it gets connected with the other ramp parts. Since I intended to make it longer, the hole whould have been in the middle of the step, so I used some leftovers from the sawing to fill it in, you can see it within the red circles:
Finally I glued it all together and now at least two figures can stand next to each other, while before only one had been able to. And the MALP also can roll through the gate now.
So it looked before:
I bought an extra Thor to get more ramp parts. I did want to make it one half wider, so I needed to cut them in the middle.
The steps were a bit more tricky, since they have a space at the left and right, where it gets connected with the other ramp parts. Since I intended to make it longer, the hole whould have been in the middle of the step, so I used some leftovers from the sawing to fill it in, you can see it within the red circles:
Finally I glued it all together and now at least two figures can stand next to each other, while before only one had been able to. And the MALP also can roll through the gate now.
Last edited by Astra on Sat Feb 14, 2009 6:16 pm, edited 1 time in total.
More of my actionfigures pictures at http://dieastra.livejournal.com/
More Action Figure Theater at http://community.livejournal.com/action_tales/
More Action Figure Theater at http://community.livejournal.com/action_tales/