| Top rated |
Lit Ribbon Device278 viewsWithout any lights on, the Ribbon Device presents a menacing glow. This photo exaggerates the effect slightly in terms of brightness, but this is a good representation. It is lit by a single red L.E.D., and powered with a 3V power cell.
(3 votes)
|
|
Upper Arm Crystal173 viewsSculpting the crystal/spiral at the top of the arm band.
(3 votes)
|
|
Lit Ribbon Device219 viewsThis is the Ribbon Device with power turned on. This prototype is unfinished on the inside of the armband. I think I will line future ones with black felt.
(2 votes)
|
|
Kneel Before Your God386 viewsFinished Ribbon Device in use.
(2 votes)
|
|
Ribbon Device Arm245 viewsFirst test casting from the mold. Needs to be trimmed and reformed. Further test casts came out much nicer.
(2 votes)
|
|
Pulling off the mold138 viewsHere the mold is pealed off of the Ribbon Device. The Jaffa lines appear to have been captured perfectly.
(2 votes)
|
|
Upper Crystal202 viewsHere is the finished sculpt of the upper crystal which sits ontop of the hand. the flat sculpt is actually upside down, and will ultimately be curled around the crystal seen to the left. Prototype sculpt is in the upper right corner; while center crystals are in the upper left.
(2 votes)
|
|
P90 Ready for Off World Use149 viewsFully completed P90 kit built using the SG1Props kit, an LPEG airsoft P90, and a TM magazine.
(2 votes)
|
|
P90 Kit Built onto an LPEG P90145 viewsIncluded is a Tokyo Marui magazine, and the P90 trademarks which are part of the SG1Props kit.
(2 votes)
|
|
Knuckle Rings200 viewsThese sculpts are of the knuckle rings. In this photo some of the Jaffa lines have not been added yet.
(2 votes)
|
|
Finger Caps179 viewsFreshly sculpted and smoothed finger caps for the Goa'uld Ribbon Device.
(2 votes)
|
|
Ribbon Device Engravings155 viewsCloseup of the markings. These are like the lines found on other Goa'uld weapons such as Zat guns and Staff weapons
(1 votes)
|
|
|
|
